6.3.10 Setting up the speed sensor
To start the metering unit(s), a speed signal is
required. The speed sensor on the implement can be
used for this.
To set up the speed sensor on the implement,
refer to the ISOBUS operating manual, "Setting
up the speed sensor on the implement".
6.3.11 Changing the implement controls
6.3.11.1 Autonomous implement controls
Depending on the equipment, the implement control
of the FTender is integrated via the job computer
of the AMAZONE implement mounted at the rear or
autonomous via its own job computer.
1.
To operate the FTender with the autonomous
ISOBUS implement controls,
disconnect the 6-pin plug
1
from the interface of
the hose package.
2.
Remove the connection cable
2
from the
conveyor section.
3.
Route the connection cable to the FTender.
1
2
CMS-I-00003744
4.
Connect the 6-pin plug
2
to the interface of the
FTender
1
.
5.
Roll up the excess length of the connecting cable.
6.
Put the excess length in the holder
3
.
3
2
1
CMS-I-00003743
CMS-T-00003210-B.1
CMS-T-00005213-A.1
CMS-T-00005214-A.1
6 | Preparing the machine
Preparing the implement for operation
MG6492-EN-II | G.1 | 26.04.2021
72
