9.3.1 The track marker collision protection is triggered.
The track marker has encountered a solid obstacle. The shear bolt is torn and the track
marker folded to the rear.
NOTE
Only use original bolts as a replacement. Refer to
the online spare parts list. Spare bolts are in the
track marker bracket
1
.
1.
Remove the damaged bolt from the overload
safety.
2.
Insert the spare bolt in the track marker boom.
3.
Tighten the spare bolt.
1
CMS-I-00002081
9.4 Cleaning the machine
IMPORTANT
Risk of machine damage due to cleaning
jet of the high-pressure nozzle
Never direct the cleaning jet of the
high-pressure cleaner or hot water
high-pressure cleaner onto the marked
components.
Never aim the cleaning jet of high-
pressure cleaners or hot water high-
pressure cleaners on electrical or
electronic components.
Never aim the cleaning jet of the high
pressure cleaner directly on lubrication
points, bearings, rating plates, warning
signs, and stickers.
Always maintain a minimum distance
of 300 mm between the high-pressure
nozzle and the machine.
Do not exceed a water pressure of 120
bar.
Clean the machine with a high-pressure cleaner
or a hot water high-pressure cleaner.
CMS-T-00002345-B.1
CMS-T-00000593-C.1
9 | Repairing the machine
Cleaning the machine
MG6214-EN-II | E.1 | 17.05.2021
70
