6.3.1.4 Adjust the working depth of the side guide plates
1.
Remove the nuts and washers
5
.
2.
To adjust the working depth of the side guide
plates
3
,
install the side guide plates in the hole pattern
4
in the desired position.
3.
Install the bolts
1
and spacers
2
.
4.
Install the nuts and washers.
5.
Operate the implement over 30 m to 50 m at
working speed.
6.
Check the seedbed.
7.
Repeat the procedure until a uniform seedbed is
produced.
CMS-I-00000946
6.3.2 Preparing the side guide plates for operation
CAUTION
Crushing hazard for hands!
Carefully telescope the side guide plates.
1.
Raise the implement.
2.
Remove the linch pin
2
.
3.
Pull out the pin
3
.
4.
To prevent ridge formation during operation,
move the side guide plates
1
to the desired
position.
5.
Secure the side guide plate with the pin.
6.
Secure the pin with the linch pin.
7.
Operate the implement over 30 m to 50 m at
working speed.
8.
Check the seedbed.
9.
Repeat the procedure until a uniform seedbed is
produced.
CMS-I-00000953
CMS-T-00001483-B.1
CMS-T-00001489-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6214-EN-II | E.1 | 17.05.2021
49
