4.
Actuate the "blue" tractor control unit.
The sections will be folded.
5.
When the sections have reached the end
position,
switch the "blue" tractor control unit to float
position.
6.4.6 Aligning the implement horizontally at transport height
6.4.6.1 Aligning implements with rigid drawbar horizontally at transport height
The graphic shows the folded implement in a
horizontal position and with the correctly set transport
height. The correct transport height is reached at the
specified height of the drawbar pivot point.
< 4 m
24,5 cm
82 cm
CMS-I-00006808
1.
Drive the tractor and implement onto a level
surface.
2.
To move the implement to the correct transport
height and align it horizontally at the correct
transport height,
actuate the control valves for the tractor lower
links and the "yellow" tractor control unit until the
the drawbar three-point is at the indicated height
and the inner side plates of the sections run
parallel to the ground.
6.4.6.2 Aligning the implement with hydraulic drawbar horizontally at transport height
The graphic shows the folded implement in a
horizontal position and with the correctly set transport
height. The correct transport height is reached at the
specified height of the drawbar pivot point.
< 4 m
24,5 cm
82 cm
CMS-I-00006809
CMS-T-00009791-A.1
CMS-T-00009792-A.1
CMS-T-00009793-A.1
6 | Preparing the machine
Preparing the machine for road travel
MG7478-EN-GB | C.1 | 19.08.2022 | © AMAZONE
61
