7.
Pull out the linch pin
3
of the top eccentric pin
1
on both sides.
8.
Pull the top eccentric pin out of the hole pattern
2
.
1
2
3
CMS-I-00004860
9.
Reinsert the top eccentric pins
1
each in the
hole
2
just above the rear rocker arm
4
. . In
doing so, turn the eccentric pin so that it rests
against the rear rocker arm without play after
being inserted.
10. Secure the top eccentric bolt with a linch pin
3
.
11. Raise the running gear into working position.
12. Using the lower links, align the implement such
that the frame is parallel to the ground lengthwise.
1
2
3
3
1
4
4
CMS-I-00004862
6.3.10 Manual adjustment of the levelling working depth
1.
Slightly raise the implement.
2.
Move the setting lever
1
from parking position.
3.
Position the setting lever in the group of holes
with the pin
2
.
4.
Slightly lift the levelling with the setting lever and
pull the pin
3
out of the group of holes.
5.
To change the working depth,
swivel the setting lever up or down.
6.
Insert the pin
3
in the group of holes.
7.
Take out the setting lever.
8.
Repeat the procedure on the other side.
1
2
3
CMS-I-00003060
CMS-T-00004167-D.1
6 | Preparing the machine
Preparing the implement for operation
MG7242-EN-GB | L.1 | 26.07.2022 | © AMAZONE
63
