6.3.9 Adjusting the working depth of the coulters
6.3.9.1 Increasing the working depth of the coulters
1.
Lower the running gear into transport position.
2.
Pull out the linch pin
3
of the top eccentric
pin
1
on both sides of the working depth
adjustment.
3.
Pull the top eccentric pin out of the hole pattern
2
.
4.
Raise the running gear into working position
until the coulters have reached the desired lower
position.
1
2
3
3
1
2
CMS-I-00004846
5.
Insert the top eccentric pins
1
through the hole
2
just above the rear rocker arm
4
on both
sides. In doing so, turn the eccentric pin so that
it rests against the rear rocker arm without play
after being inserted.
6.
Secure the top eccentric pin with the linch pin
3
on both sides.
1
2
3
4
CMS-I-00004847
7.
Pull out the linch pin
3
of the bottom eccentric
pin
1
on both sides.
8.
Pull the bottom eccentric pin out of the hole
pattern
2
.
1
2
3
CMS-I-00004848
CMS-T-00006916-B.1
CMS-T-00006908-B.1
6 | Preparing the machine
Preparing the implement for operation
MG7242-EN-GB | L.1 | 26.07.2022 | © AMAZONE
61
