7.
With the help of a guide, drive with the implement
in reverse over the parked roller.
8.
Raise the running gear into working position
using the "yellow 1" tractor control unit, until the
roller mounts are resting on the roller.
9.
Fasten the roller on the roller mounts
2
with
clamping brackets
3
and bolted connections
1
.
10. Lower the running gear into transport position
using the "yellow 2" tractor control unit.
1
2
3
CMS-I-00004822
11.
If the roller is a single roller with mounted
roller holder:
Remove the linch pins
2
on the parking legs
3
of the roller holder.
12. Pull the parking legs out of the mount
1
.
13. Put the parking legs in parking position in the top
holes of the mount.
14. Secure the parking legs with linch pins.
1
2
3
CMS-I-00004835
6.3.2 Unlocking the tractor control units
Depending on the equipment, unlock the tractor
control units mechanically or electrically.
6.3.3 Removing the road safety bars
1.
Remove the road safety bars from the rear
harrow.
2.
Turn the traffic safety bars
1
by 180°, place on
top of each other on the brackets
2
.
3.
Secure the road safety bars with tensioners
3
.
CMS-I-00000518
CMS-T-00006819-B.1
CMS-T-00000091-C.1
6 | Preparing the machine
Preparing the implement for operation
MG7242-EN-GB | L.1 | 26.07.2022 | © AMAZONE
55
