General safety instructions
26
Cenius03-2TX BAG0112.13 07.21
2.16.3 Electrical system
•
When working on the electrical system, always disconnect the
battery (negative terminal).
•
Only use the prescribed fuses. If fuses are used that are too
highly rated, the electrical system will be destroyed – danger of
fire!
•
Ensure that the battery is connected correctly - firstly connect the
positive terminal and then connect the negative terminal. When
disconnecting the battery, disconnect the negative terminal first,
followed by the positive terminal.
•
Always place the appropriate cover over the positive battery
terminal. There is a danger of explosion in the event of an acci-
dental earth contact!
•
Danger of explosion! Avoid the production of sparks and naked
flames in the vicinity of the battery!
•
The machine can be equipped with electronic components, the
function of which may be influenced by electromagnetic interfer-
ence from other units. Such interference can pose risks to peo-
ple, if the following safety information is not followed.
ο
In the case of retrofitting of electrical units and/or compo-
nents on the machine, with a connection to the on-board
power supply, the user must check whether the installation
might cause faults on the vehicle electronics or other com-
ponents.
ο
Ensure that the retrofitted electrical and electronic compo-
nents comply with the EMC Directive 2004/108/EC in the
latest version and bear the CE mark.
2.16.4 Coupled machines
•
Observe the permitted combination options of the attachment
equipment on the tractor and the machine drawbar.
Only couple permitted combinations of vehicles (tractor and at-
tached machine).
•
On single axle machines, observe the maximum permitted draw-
bar load of the tractor on the attachment equipment.
•
Ensure that the tractor has sufficient steering and braking power.
Machines attached or coupled to a tractor influence the driving
behaviour and steering and braking power of the tractor, and in
particular single axle machines with drawbar loads on the tractor.
•
Only one specialist workshop can adjust the height of the draw-
bar if it is a straight drawbar with drawbar load.
•
Implements without brake system:
Observe the national regulations for implements without brake
system.
