General safety instructions
22
Cenius03-2TX BAG0112.13 07.21
2.16
Safety information for users
WARNING
Before starting up the machine and the tractor, always check
their traffic and operational safety.
2.16.1 General safety and accident prevention information
•
Beside these instructions, comply with the general valid national
safety and accident prevention regulations.
•
The warning pictograms and labels attached to the machine
provide important information on safe machine operation. Com-
pliance with this information guarantees your safety!
•
Before moving off and starting up the machine, check the imme-
diate area of the machine (children)! Ensure that you can see
clearly!
•
It is forbidden to ride on the machine or use it as a means of
transport!
•
Drive in such a way that you always have full control over the tractor
with the attached machine.
In so doing, take your personal abilities into account, as well as
the road, traffic, visibility and weather conditions, the driving
characteristics of the tractor and the connected machine.
Connecting and disconnecting the machine
•
Only couple and transport the machine with a tractor which has
been designed for this task and fulfils the power requirements.
•
When connecting machines to the tractor three-point hydraulic
system, the attachment categories of the tractor and the ma-
chine must always be the same!
•
When coupling machines to the front or the rear of the tractor,
the following may not be exceeded:
ο
The approved total tractor weight
ο
The approved tractor axle loads
ο
The approved load capacities of the tractor tyres
•
Secure the tractor and the machine against unintended rolling
away before mounting or dismounting the machine.
•
It is forbidden for people to stand between the machine to be
coupled and the tractor, whilst the tractor is moving towards the
machine!
Any helpers may only act as guides standing next to the vehi-
cles, and may only move between the vehicles when both are at
a standstill.
•
Before mounting and dismounting the machine to the three-point
linkage secure the control lever for the tractor hydraulics in such
a position that an unintended lifting or lowering is impossible.
•
When coupling and uncoupling machines, move the support
equipment (if available) to the appropriate position (stability).
•
When actuating the support equipment, there is a danger of inju-
ry from contusion and cutting points!
