Cleaning, maintenance and repairs
Cenius03-2TX BAG0112.13 07.21
123
12.14.4 Installation and removal of hydraulic hose lines
When installing and removing hydraulic hose lines, always observe
the following information:
•
Only use AMAZONE original hydraulic hose lines.
•
Ensure cleanliness.
•
You must always install the hydraulic lines so that, in all states of
operation:
ο
There is no tension, apart from the hose's own weight.
ο
There is no possibility of jolting on short lengths.
ο
Outer mechanical influences on the hydraulic hose lines
are avoided.
Use appropriate arrangements and fixing to prevent any
scouring of the hoses on components or on each other. If
necessary, secure hydraulic hose lines using protective co-
vers. Cover sharp-edged components.
ο
The approved bending radii may not be exceeded.
•
When connecting a hydraulic hose line to moving parts, the hose
length must be appropriate so that the smallest approved bend-
ing radius is not undershot over the whole area of movement
and/or the hydraulic hose line is not over-tensioned.
•
Fix the hydraulic hose lines to the intended fixing points. Avoid
using hose clips in places where they impede the natural move-
ment and length changes of the hose.
•
Painting over hydraulic lines is not permitted.
12.15 Lower link pins
WARNING
Risk of contusions, catching, and knocks when the machine
unexpectedly releases from the tractor!
Check the lower link pins for visible damage each time you couple the
machine. Replace lower link pins if there are clear signs of wear.
