Cleaning, maintenance and repairs
100
Cenius03-2TX BAG0112.13 07.21
12.1
Cleaning
•
Pay particular attention to the brake, air and hydraulic hoses!
•
Never treat brake, air and hydraulic hoses with petrol, benzene,
petroleum or mineral oils.
•
After cleaning, grease the machine, in particular after cleaning
with a high pressure cleaner/steam jet or liposoluble agents.
•
Observe the statutory requirement for the handling and removal
of cleaning agents.
Cleaning by using a high pressure cleaner / steam jet
•
Always observe the following points when using a high pressure
cleaner/steam jet for cleaning:
ο
Do not clean any electrical components.
ο
Do not clean any chrome-plated components.
ο
Never aim the cleaning jet of the cleaning nozzle of the
high pressure cleaner/steam jet directly at lubrication
points, bearings, rating plates, warning signs, and stickers.
ο
Always maintain a minimum jet distance of 300 mm be-
tween the high pressure or steam jet cleaning nozzle and
the machine.
ο
The set pressure of the high-pressure cleaner/steam jet
must not exceed 120 bar.
ο
Comply with the safety regulations when working with high
pressure cleaners.
12.2
Lubrication instructions
Grease all lubricating nipples (keep seals clean).
Lubricate/grease the machine at the specified
intervals.
Lubrication points on the machine are indicated
with the foil (Fig. 62).
Carefully clean the lubrication points and grease
gun before lubrication so that no dirt is pressed
into the bearings. Press the dirty grease out of
the bearings completely and replace it with new
grease.
Fig. 58
