Brief instructions
13
Brief instructions
Coupling
1. Couple the supply lines with the tractor.
2. Check that the stop tap for the disc array is closed.
3. Open both stop taps on the drawbar hydraulic cylinder.
4. Activate tractor control unit
green
.
4.1 Lower the drawbar and attach the coupling device with the
tractor.
4.2 Lift the drawbar.
5. Remove both jacks and mount them on the side of the drawbar.
6. Disengage parking brake.
7. Remove wheel chocks.
8. Activate tractor control unit
green
.
→
Lower the implement using the drawbar until the implement
height is lower than 4 m.
9. Activate tractor control unit
blue
.
→
Fold in – brace the sections against each other.
10. Perform a visual inspection of the section locking mechanism.
11. Close both stop taps on the drawbar hydraulic cylinder.
Uncoupling
1. Check that the stop tap for the disc array is closed.
2. Open both stop taps on the drawbar hydraulic cylinder.
3. Activate tractor control unit
green
.
→
Lift drawbar.
4. Remove both jacks and mount them on the parking position.
5. Activate tractor control unit
green
.
→
Park the implement on the jacks.
6. Apply the parking brake.
7. Position the wheel chocks.
8. Disconnect the supply lines.
9. Disconnect the coupling device.
10. Close both stop taps on the drawbar hydraulic cylinder.
Catros BAG0110.10 10.19
111
