Amazone AmaTron 4, Operating Instructions Manual, Page: 76 / 111

Using part-width section control
Q
1
Overlap, setting
1.1 Defining the overlap in the direction of travel
The overlap in the direction of travel indicates how far
the part-width sections can protrude over a boundary in
the direction of travel before the part-width sections are
switched off. Overlap in the direction of travel prevents
gaps from occurring between the headlands and the
rows or between the worked areas. Moreover, the pre-
start times can be compensated, which can be different
depending on the implement.
The overlap in the direction of travel can be set
separately for switching the part-width sections on and
off.
NOTE
If a gap is intended between the headlands and the
rows or between the worked areas, a negative value
can also be entered for the overlap in the direction of
travel. This prevents, for example, the seed rows from
overlapping.
Boundaries for the overlap in the direction of travel:
Boundary from unworked to worked area
Headland boundary
CMS-T-00000189-D.1
CMS-T-00000286-C.1
CMS-T-00000287-C.1
Q | Using part-width section control |
MG6010-EN-GB | G.1 | 13.12.2018 74