3. Enter a name for the implement under
"Name"
.
4.
If an AMABUS implement is connected,
select the connected implement under
"Implement
type"
.
NOTE
The implement type can only be selected if the AMA-
TRON 3 was started in AMABUS mode, see page 18.
5. Under
"Number of part-width sections"
, enter the
number of part-width sections for the implement.
6.
To assign all of the part‐width sections with the
same width,
enter a common value for all part-width sections un-
der
"Standard part-width section"
.
7.
If a width should be assigned to a specific part‐
width section,
enter a value for the respective part-width section
under
"Part-width section no.:"
.
NOTE
The numbering of the part width sections is carried
out from left to right in the direction of travel.
1.1 Editing the implement geometry data
For the GPS switch to function properly, the implement
geometry data is required. The part-width section con-
trol, track guidance and variable rate control depend on
the correct geometry.
1. Select
"Implement data"
>
"Geometry data"
.
007577
H | Configuring implements | Editing the implement data
MG5560-EN-II
| B.1 | 2016.07
45