Possible settings:
: The BUS mode can be selected when the AMA-
TRON 3 is started.
: The AMATRON 3 always starts in AMABUS mode
: The AMATRON 3 always starts in ISOBUS mode
1.6 Configuring parallel operation
Multiple terminals can be used simultaneously. To be
able to use several terminals at the same time, the ISO-
BUS must be configured in the ISOBUS settings and if
applicable, in the implement controls (UT), see page 27.
This menu defines which functions should be performed
by the AMATRON 3. If for example two AMATRON 3 ter-
minals are being used, one AMATRON 3 can be used to
display the implement controls and the other AMATRON
3 for the GPS functions.
Select
"Setup"
>
"Settings"
>
"Parallel operation"
.
Possible settings:
: The AMATRON 3 can be used to access the im-
plement controls and the GPS functions are available.
: The AMATRON 3 can only be used to access the
implement controls. The Task Controller is signed off of
the BUS.
: Only the GPS functions are available on the AMA-
TRON 3. The UT is signed off of the BUS
2
Defining the AUX-N assignment
With the AUX-N assignment, specific functions of the
AMATRON 3 and the implement can be assigned to but-
tons on an external input device. However, the AMA-
006885
006877
G | Configuring the setup | Defining the AUX-N assignment
MG5560-EN-II
| B.1 | 2016.07
33