Amanda Amanda@Work.Place Version 3.xx, Installer'S Manual

Page: 191 / 206

Appendix C: Configuration Reference 183
smdi_delay The time that Amanda waits after the phone rings and is answered, before looking at the
integration information (if any).
Use a number of tenths of seconds or 0. The default is 0. The range is 0-255. This option
does not apply to inband integration.
When non-zero, Amanda waits the specified time. This allows more than one string to
be sent to a given port per telephone call. The number should allow enough time for all
the strings to arrive, forcing Amanda to use only the last (most recent) one. (The inte-
gration time specified in the 1001.PBX configuration file can be zero or near zero, be-
cause Amanda has already waited for smdi_delay time to pass.)
For example, if smdi_delay is set to 30 (3 seconds), it is OK to use a pattern such as in-
tegration 1 '...', which designates a 0.1-second integration timeout because Amanda
waits 3 seconds for the last packet to be received.
The default appears in install.cfg as:
set smdi_delay 0
smdi_max The maximum number of characters expected in a generic SMDI packet.
The default is 143. The range is from 1 to 143. Use this when smdi_type is 'generic'.
The default appears in install.cfg as:
set smdi_max 143
smdi_port The logical serial port (represented by serial_port n ) to use for SMDI integration. The
port should already have been configured as a serial port using the options in the Serial
section of Advanced Configuration.
The range is 0 to 4. The default is 0 (no serial port used).
The default appears in install.cfg as:
set smdi_port 0
smdi_pretimeout The maximum number of seconds that an SMDI packet can precede the forwarded call.
The default is 50. The range is from 1 to 99. Use this when the smdi_type is 'smdi', 'nec-
mci', or 'generic'.
The default appears in install.cfg as:
set smdi_pretimeout 50
smdi_start The position in the integration packet sent by the telephone switching system where the
field containing the port number begins. The first position in the packet is number 1.
Use this option when smdi_type is 'necmci' or 'generic'.
The default is 8. The range is 0-65535.
The default appears in install.cfg as:
set smdi_start 8
smdi_stop The position in the integration packet sent by the telephone switching system where the
field containing the port number ends. The first position in the packet is number 1.
Use this option when smdi_type is 'necmci' or 'generic'.
The default is 11. The range is 0-65535.
The default appears in install.cfg as:
set smdi_stop 11
SMDI Options (Continued)