7
3.
Remove drain hose form
(floor drain installations only)
For floor drain installations, you will need to remove the
drain hose form from the end of the drain hose. You may
need additional parts with separate directions. See “Tools
and Parts.”
Connect Inlet Hoses
The washer must be connected to the water faucets using
new inlet hoses (not provided). Do not use old hoses.
4.
Insert new flat washers into
inlet hoses
Coupling
Washer
Insert new flat washers (not provided) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
5.
Connect inlet hoses to water faucets
Check that the washer basket is empty.
Attach hose to hot water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings an
additional two-thirds turn. Repeat this step with second hose
for cold water faucet.
IMPORTANT: Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
6.
Clear water lines
Run water for a few seconds through hoses into a laundry tub,
drainpipe, or bucket to avoid clogs. Water should run until clear.
Make note of which hose is connected to hot water to help in
attaching hoses to washer correctly.
