Model DWA63A Operating Instructions
Wash Cycles
Wash Cycle/Cycle Time/Water Used
Cycle selection procedure
Sequence
Pots & Pans (83 minutes) (7.2 gallons/ 27.3 liters)
For pots, pans, casseroles and dinnerware with dried-
on or baked-on soils.
1. Turn dial to
POTS & PANS.
2. Select
WASH TEMP BOOST and any other
desired option.
Wash, rinse,
rinse, wash,
rinse, rinse, dry
Normal Wash (75 minutes) (6 gallons/22.7 liters)
For regularly soiled dishes and silverware.
1. Turn dial to
NORMAL WASH.
2. Select desired options.
Wash, rinse,
wash, rinse,
rinse, dry
Light Wash (68 minutes) (4.8 gallons/18.2 liters)
For lightly soiled or pre-rinsed dishes and silverware.
1. Turn dial to
LIGHT WASH.
2. Select desired option.
Rinse, wash,
rinse, rinse, dry
Rinse/Hold (5 minutes) (1.2 gallons/4.5 liters)
For rinsing dishes that will be washed later.
1. Do not use detergent.
2. Turn dial to
RINSE/HOLD.
Rinse
Plate Warmer (14 minutes)
For warming dishes and serving plates before serving
hot foods.
1. Load clean plates and dishes to be
warmed.
2. Turn dial to
PLATE WARMER.
3. Select
HEATED DRY.
Hot dry
Delay Hours (6 hours)
Allows you to delay starting the
POTS & PANS cycle
for up to 6 hours.
1. Turn dial to desired time delay.
2. Select
WASH TEMP BOOST option and other desired options.
DELAY START light will come on when door is closed.
Important
Before operating dishwasher read
Important Safety
Instructions, Preparing and Loading Dishes, Dishwasher
Dispenser and Detergents and Rinse Aid sections of owner’s
manual.
1.
Load dishwasher (See
Preparing and Loading Dishes
section of
owner’s manual).
2.
Add detergent (See
Dishwasher Dispenser and
Detergents section of owner’s manual).
3.
Add rinse aid if needed (See
Rinse Aid section of owner’s
manual).
4.
Turn dial clockwise to select cycle (See
Wash Cycles
chart below) or number of hours for delayed start.
5.
Select desired energy options. See
ENERGY
OPTIONS. The indicator light will show red when an
option is selected.
6.
If using
DELAY HOURS, go to step number 8.
7.
Run hot water faucet nearest dishwasher until water is
hot. Turn water off (Optional).
8.
Close door to latch and start dishwasher.
NOTE: Cycle times are approximate and will vary with options
selected. Hot water is necessary to activate dishwasher
detergent and melt fatty food soils. An automatic sensor will
check the incoming water temperature and, if not high enough
will delay timer, and automatic water heating takes place. This
will happen even when
WASH TEMP BOOST is not selected.
When
WASH TEMP BOOST is selected, an even higher
temperature will be guaranteed to handle heavier soil loads.
