RS1200004 Rev. 0
B - 6
Contour Door Reversal
1.
Remove buckets from fresh food and freezer doors.
2.
Pry off top hinge cover. Use 5/16" nut driver to
remove top-hinge mounting screws. Remove top
hinge and shims (if present). Save all parts for reuse.
3.
If unit is equipped with a Posi-Pin locator shim,
carefully peel locator off top of refrigerator and lay it
aside where the adhesive backing will stay clean.
Posi-Pin shim
Top hinge shim
Top hinge
Screws
Plastic cap
Top Hinge Nomenclature
3.
Lift refrigerator door off center hinge pin. Be sure that
door closure and all shims stay on center hinge pin.
Set door aside on a clean, padded surface to protect
the finish and customer’s property.
4.
On top of cabinet, side opposite hinge, use putty
knife to remove three button plugs. Press plugs into
holes vacated by hinge removal.
5.
Use a 5/16" nut driver (some units require a 9/32"
nut driver) to remove the center hinge pin. Note
location of all shims (above or below hinge). Retain
all parts for use in reassembly.
6.
Lift freezer door off bottom hinge and set door aside
on a clean, padded surface to protect the finish and
customer’s property. Verify that all shims stay with
bottom hinge pin.
7.
Remove toe grille and bottom-hinge cap(s).
8.
From the center mullion, side opposite hinge, use
5/16" nut driver to remove 3 screws. Retain screws
for reuse in Step 8.
Door
shim
Center
hinge pin
Hinge
shims
Center hinge
bracket
3 Screws
3 screws
Center
mullion
Center Hinge Nomenclature
20. On top edge of freezer door, on side opposite hinge,
use a No. 2 Phillips screwdriver to install freezer door
handle and cap.
21. Set refrigerator door on center hinge pin and install
the top hinge. Be sure all shims are present and
correctly located. Replace the plastic hinge cap.
22. Install refrigerator handle and handle trim caps.
23. Install toe grille by snapping it into place.
Installation Instructions