Amada ML-7 Series, Operation Manual, Page: 25 / 93

21
ML-7 Series/ML-9001A
Installation
■
Control Unit
Refer to the following figure when determining a location to install the Control Unit. For more efficient
cooling, choose a location where the marker is not too close to the walls. Additionally, make sure the
front of the unit is easily accessible.
Required Clearance and Mass Support:
3.1 Installation Requirements
Vibration or impact may cause misalignment of the optical axis, reductions in laser power,
disconnection or looseness of electrical components, or may damage the equipment in other
ways. Always use the specified packaging material to prevent vibration or impact, especially
during transport or relocation. Do not transport the marker while it is installed on an automatic
unit.
Note that if the marker is subjected to even weak vibration over an extended period, the
electrical components and marking quality be may affected.
ML-7111A ML-7112AH ML-9001A ML-7064A
A. Clearance on top At least 500 mm At least 200 mm At least 500 mm At least 100 mm
B. Clearance on both
sides
At least 220 mm At least 200 mm At least 220 mm At least 500 mm
C. Clearance in back At least 350 mm At least 350 mm At least 350 mm At least 500 mm
D. Mass 24 kg 30 kg 24 kg 72 kg
Air intake/exhaust Front/back Front/back Front/back Front/back/both sides
B
B
(Front) (Back)
C
(Back) (Front)
Optical Fiber
Bending
Radius:
150 min.
(Bottom)
D
(Top)
A
Chapter
3