Amada ML-3015AS, Operation Manual, Page: 96 / 204

96
ML-3030AS/3015AS
4 . Setting the Laser Light Output Schedule
MODULATION Sets the modulation degree of the laser output value.
Sets the modulation width whose center is the laser output peak value (100%
output value) in the range of 0 to 100% as a percentage of power.
<Note>
The modulation width can be set in the range from the minimum value of
laser output (ML-3030AS: 0.5 kW, ML-3015AS: 0.25 kW) to the maximum
value of the laser output peak value set on the SCHEDULE screen.
Ex.) When "PEAK POWER" is 2.160 kW on ML-3030AS, the result is "PEAK
POWER 2.160 kW x Upward modulation width 25% = 2.700 kW." The
setting more than 50% cannot be set.
FREQUENCY Sets the frequency of the laser output value.
The setting range is 1 to 5000 Hz. Sets the cycle of modulation.
MODU Set the modulation function to ON or OFF.
When this item is set to ON, the settings is enabled. When the item is set to
OFF, this function is disabled.
<Note>
When using the modulation function, set the laser output value (POWER [%])
to 100%.
WAVE Sets the type of modulation waveform from rectangular wave (RECT), trian-
gular wave (TRI), or sinusoidal wave (SINE).
X Returns to the SCHEDULE screen.
⇒ For the common items in the upper/lower part of the screen, refer to page 59.
25%
25%
2.160 kW
2.700 kW
Modulation = 50%