Amada ML-3015AS, Operation Manual, Page: 91 / 204

4 . Setting the Laser Light Output Schedule
91
ML-3030AS/3015AS
Chapter 2 V
arious Settings
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
4
Checking Output Schedules
(1) Check the waveform displayed on the screen.
The set laser output time and laser output value are graphically displayed and
the output laser light can be checked as a waveform.
⇒
At the leading edge of waveform, an overshoot (higher form than the set value)
may occur. In this case, extend "

SLOPE" by 0.1 to 1.0 ms.
(2) Check the output energy displayed in "REFERENCE VALUE."
⇒
In "REFERENCE VALUE", the forecast value of laser output energy based on the
set output schedules is displayed. This value is a little different from the actually
measured value (measured value displayed on the MONITOR screen) provided
at laser welding. However, use it as reference.
↑ SLOPE 0.6ms
FLASH1 3.6ms
FLASH2 2.4ms
FLASH3 1.9ms
↓ SLOPE 1.2ms
Pulse width 7.9ms
10ms
100%