Amada ML-3015AS, Operation Manual, Page: 40 / 204

40
ML-3030AS/3015AS
1 . Installation Place
Space Required for Installation
In the installation place of this product, a space is required in the surroundings.
Install the product in a place remote from the wall as shown in the following figure.
⇒
Air flows in the direction of the red arrow shown in the following figure. Install the
product so as not to interrupt the air flow.
Environment Suitable for Installation and Precautions
⇒ In laser processing, dust and fumes are generated from workpiece. Depending
on the kind of workpiece, they may adversely affect a human body. Also, dust
and fumes from workpiece may cause staining and burning of optical parts and
lower the laser output. Furthermore, if conductive dust enters the laser equip-
ment, a short circuit accident may occur to cause malfunction. Therefore, in laser
processing, be sure to install an exhaust device such as dust collector and blow-
er in a proper position to keep a clean environment.
⇒
Use the product in a place where the ambient temperature is 10 to 35ºC and the
ambient humidity is 50 to 85% RH and yet a sudden temperature change does
not occur.
⇒
Avoid operating the product in the following places because a failure may occur.
■
Place where there is considerable dirt, dust, or oil mist,
■
where the Laser may be subjected to vibration or impact,
■
where the Laser may be exposed to chemicals,
■
where there is a nearby high noise source,
■
where moisture may be condensed on the surface of the Laser,
■
where the concentration of CO
2
, NOx or SOx is high.
⇒
When a sudden temperature change occurs, for example, at a start of heat-
ing, condensation will be caused to the surface of the lens or the mirror, thereby
sticking dust there. Avoid such a sudden temperature change if possible. When
there is a possibility of condensation, turn ON the power supply of the laser. In
about 2 hours, start to operate the laser.
FIBER .OUT 1
500mm
500mm
200mm
500mm
200mm