Amada ML-3015AS, Operation Manual, Page: 33 / 204

2 . Name and Function of Each Section on the Top Side
33
ML-3030AS/3015AS
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
2 . Name and Function of Each Section on the Top Side
This section explains each section of the top side of the main unit .
Function of Each Section on the Top Side
(1) Optical Fiber In-
lets
Pass the optical fibers through these holes.
(2) Optical Fiber Fix-
tures
Secures the optical fiber. The numbers and positions are different ac -
cording to the sharing specification.
(3) EMERGENCY
STOP Button
This is an emergency stop button. With this button pressed, the laser
welder operation is stopped and the same state as that provided by
turning OFF the CONTROL keyswitch is provided. When the pressed
button is turned in the direction of RESET (clockwise), the button is re-
set to the initial state.
(4) LASER
START/STOP
(Button)
EMISSION
( Lamp)
If you press the button when a laser light output becomes ready, laser
light is output. If the button is pressed again while laser light is repeat-
edly output, the repeated output is stopped.
* Pin No.25 (control switching) of the EXT. I/O (1) connector is in a
closed circuit and the LD is turned on.
When the LD is turned on, the EMISSION lamp comes on.
(5) Control Panel This panel is used to set welding schedules and operate the laser.
Setting items and set values are displayed on the liquid crystal display.
Chapter 2 Name and Functions of Each Section
FIBER.OUT 1
(8)
(5)
(3)
(10)
(7)
(9)
(6)
(4)
(1)
(2)