Amada ML-3015AS, Operation Manual, Page: 177 / 204

Specifications
177
ML-3030AS/3015AS
Specifications
Item ML-3030AS ML-3015AS
Oscillator
Maximum rated
output (from
oscillator) *1 *2
REPEAT mode 0.3 kW 0.15 kW
CW mode 270 W 135 W
Maximum peak
power (from
oscillator) *1
REPEAT mode
Maximum: 2.7 kW
Minimum: 0.5 kW (PFB ON),
0.3 kW (PFB OFF)
Maximum: 1.35 kW
Minimum: 0.25 kW (PFB ON),
0.15 kW (PFB OFF)
CW mode
Maximum: 270 W
Minimum: 50 W (PFB ON),
30 W (PFB OFF)
Maximum: 135 W
Minimum: 25 W (PFB ON),
15 W (PFB OFF)
Pulse width *2
REPEAT mode
Standard: 0.2–50.00 ms (0.05
ms steps)
[Energy (J)] x [Repetition (pps)]
= 0.300 kW or less
However, the pulse energy is 30
J or less and the DUTY is 50%
or less.
<Note>
When using the output wave-
form of 0.600 kW, the pps value
is limited to keep the average
power below 0.300 kW. As a
result, the duty ratio becomes
50% or less. Also, when out-
putting a waveform with a shot
(SHOT = 1), the READY signal
is automatically turned off for
certain time after laser output to
keep the average power below
0.300 kW, and the next laser
start is not accepted.
Standard: 0.2–50.00 ms (0.05
ms steps)
[Energy (J)] x [Repetition (pps)]
= 0.150 kW or less
However, the pulse energy is 15
J or less and the DUTY is 50%
or less.
<Note>
When using the output wave-
form of 0.300 kW, the pps value
is limited to keep the average
power below 0.150 kW. As a
result, the duty ratio becomes
50% or less. Also, when out-
putting a waveform with a shot
(SHOT = 1), the READY signal
is automatically turned off for
certain time after laser output to
keep the average power below
0.150 kW, and the next laser
start is not accepted.
CW mode
Standard: 0.1–1000.0 s (0.1s steps)
Setting switching: 0.001–10.000 s (0.001s steps)
0.01–100.00 s (0.01s steps)
1–10000 s (1s step)
Repeated number of pulse/modu-
lation
1 to 1000 pps (REPEAT mode)
Modulation function
1 to 5000 Hz (rectangular wave, triangular wave, sinusoidal wave)
(CW mode)
Oscillation wavelength 1070 ± 3 nm
Safety shutter With open/close sensor
Positioning guide beam Built-in visible laser (red)
Prevention of reflected beam Built-in reflected beam sensor
Output stability ±2% @ max. rated output / 4 hours (constant temperature)
*1 When the optional isolator is mounted, the laser power output from the fiber de -
creases by up to 10%.
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part