Amada ML-3015AS, Operation Manual, Page: 113 / 204

3 . Operating Procedure
113
ML-3030AS/3015AS
Chapter 3 Laser W
elding by Control Panel (P
ANEL
CONTROL)
Introduction Part
Installation
and
Preparation
Part
Operating Part
Maintenance Part
Appendixes
3 . Operating Procedure
This section explains the operating procedure for laser welding to be controlled
from the control panel .
⇒
For the details of welding schedule settings, refer to Chapter 2, "4. Setting the
Laser Light Output Schedule" on page 83. For connector functions, refer to
Chapter 4, "3. Connector Functions" on page 121.
⇒
Before turning on the power supply, put pin No.25 (control switching) of the EXT.
I/O (1) connector to an open circuit to invalidate external input signals. As a re-
sult, the control by external input signals (EXTERNAL CONTROL) is invalidated
and "PANEL CONTROL" is displayed in "CONTROL DEVICE" on the STATUS
screen.
1
Starting the Laser
(1) Turn ON the MAIN POWER switch at the front of the main unit.
The power supply is turned ON and the POWER lamp comes on.
The timesharing unit, safety shutter, memory, and power supply unit are auto-
matically checked. When no error is found, the KEY SWITCH CHECK !! screen
is displayed.