Amada ML-3015AS, Operation Manual, Page: 111 / 204

1 . Operation Flow
111
ML-3030AS/3015AS
Chapter 3 Laser W
elding by Control Panel (P
ANEL
CONTROL)
Introduction Part
Installation
and
Preparation
Part
Operating Part
Maintenance Part
Appendixes
Chapter 3
●
Laser Welding by Control Panel
(PANEL CONTROL)
1 . Operation Flow
This section explains a laser welding operation flow by control panel.
The following methods for laser welding operations are available: control from the
control panel (PANEL CONTROL), control by external input/output signals from the
connected PLC (Programmable Logic Controller) (EXTERNAL CONTROL), and con-
trol by sending a command from the connected personal computer (RS-485 CON-
TROL).
At PANEL CONTROL, welding schedules are set by using the control panel and laser
light is output.
Operating Part
MAIN POWER switch ON
CONTROL keyswitch ON
SCHEDULE
Screen
Setting and registration of SCHEDULE
number (output schedule number) and output
schedules
Control method check (PANEL CONTROL)
LD: ON (LD ON)
BEAM: ON (safety shutter selection)
GUIDE: ON (guide light output)
SCHEDULE number input
SCHEDULE Screen
or
MONITOR Screen
Laser light output
MONITOR
Screen
Laser energy/average power check
STATUS
Screen
LD: OFF
BEAM: OFF
GUIDE: OFF
CONTROL keyswitch OFF
MAIN POWER switch OFF
Pressing the LASER START/STOP button