Amada ML-2550A, Operation Manual

Page: 67 / 229

1. Setting Welding Schedules
67
ML-2550A/2551A
Chapter 2 V
arious Settings
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
SEAM Sets the fade function (*) to ON or OFF.
*: Laser output value adjusting function. The laser energy is increased
decreased slowly to provide a continuous waveform suitable for seam
welding.
When this item is set to ON, the fade function for seam welding is enabled.
When the item is set to OFF, this function is disabled. When this function is not
used, set it to OFF.
COOL Sets the COOL1/COOL2.
COOL1: Sets a value other than 0.0 ms to insert the non-laser output time
between FLASH1 and FLASH2.
COOL2: Sets a value other than 0.0 ms to insert the non-laser output time
between FLASH2 and FLASH3.
REPEAT Sets the number of laser light outputs per second in the range of 000 to 500 pps
(pulse per second). When 0 is set, the single output is set.
Common to "REPEAT" on the SEAM screen.
SHOT Sets the number of laser outputs in the range of 0000 to 9999.
When the laser output count reaches the set value, the laser output is stopped.
When 1 is set, a single-shot output is performed.
When "REPEAT" is set to a value other than 0 and "SHOT" is set to 0, laser light
is continuously output until a laser stop signal is input.
Common to "SHOT" on the SEAM screen.
⇒
For the common items in the upper/lower part of the screen, refer to page 63.
STATUS Screen
On the STATUS screen, the laser control method is checked and it is set that the
branch shutter to output laser light is opened. In addition, the total number of laser
light outputs and the appropriate number of outputs are set.
How to see the displayed items
: Settable item
POSITION
BLINK
Sets the guide light blinking status (POSITION) or continuous lighting to ON or OFF.
When POSITION BLINK is set to ON with the guide light ON, the guide light
blinks. If it is set to OFF, the guide light is put into a continuous ON status.