Amada ML-2550A, Operation Manual

Page: 34 / 229

34
ML-2550A/2551A
2. Name and Function of Each Section on the Top Side
(3) Circuit Cable
Connector
Connect the supplied circuit cable to this connector. Connect the other
end of the cable to the Laser.
(4) EMERGENCY
STOP
(Button)
This is an emergency stop button. With this button pressed, the laser
welder operation is stopped. When the pressed button is turned in the
direction of RESET (clockwise), the button is reset to the initial state.
This button functions in the same way as the EMERGENCY STOP
button of the main unit.
Laser Oscillator Section
The laser oscillator section that makes its appearance after the top cover is
opened, and the inside that makes its appearance after branch unit cover is
removed, are explained below.
Function of Each Laser Oscillator Section
(1) Fixtures The yellow fixtures used to lock the laser oscillator to prevent any
damage or dislocation during transportation. Be sure to remove these
two fixtures before starting operations.
M4
M4
Status where the top cover is open
Status where the branch unit cover is removed
(1)
(2)
(9)
(8)
(7) (6) (5) (4)
(3)
(12) (11) (10)