Amada ML-2550A, Operation Manual

Page: 108 / 229

108
ML-2550A/2551A
2. Setting the Laser Light Delivery
Controlling Branch Shutters Independently
In the following, the method of setting branch shutters to independent control
by setting DIP switches.
⇒ Usually, the sharing specification is changed by our engineer.
When "SHUTTER 1" to "SHUTTER 4" are set to ON and the branch shutter is
opened, the branch shutter and the timesharing unit are automatically operated to
transmit laser light. When branch shutters are put under independent control, the
timesharing unit and the branch shutter are not operated in the interconnected form
even if "SHUTTER" is set to ON. Accordingly, laser light can be transferred by a
sharing method other than the prepared 8 types of sharing specification.
The DIP switches of SW2 is provided on the CPU board in the main unit. The
branch shutter independent control function is assigned to No.5, 6, 7, and 8 of SW2.
Accordingly, remove the side cover of the main unit and set SW2 to ON/OFF for this
setting.
Setting Independent Control
(1) Remove the side cover of the main unit and set No.5 of DIP switch SW2 to ON,
No.6 to OFF, and No.7 and No.8 to ON.
The branch shutter independent control is set and the MEMORY SWITCH screen
is displayed from the INITIALIZE screen. As a result, it is possible to set that only
an optional branch shutter and timesharing unit can be operated.
Set No.5 to ON.
Set No.6 to ON.
Set No.7 to ON.
Set No.8 to ON.
Branch shutter independent control
SW2
1 2 3 4 5 6 7 8
O F F
SW2
1 2 3 4 5 6 7 8
O F F
Remove the screws of the side cover,
raise the cover, and pull it out forward.
Set the branch shutter independent
control by SW2.