Amada ML-2350A-CE, Operation Manual, Page: 83 / 235

1. Setting Welding Schedules
83
ML-2350A/2351A
Chapter 2 V
arious Settings
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
Setting the Output Conditions for Seam Welding
(SEAM Screen)
The method of setting the output waveform for seam welding by using the
fade-in/out function after displaying the SEAM screen is explained below. The
fade function increases or decreases the laser energy in a gently-sloping form
to obtain a continuous waveform suitable for seam welding. As a result, the
finished status of seam welding is made beautiful.
⇒
The fade function ON/OFF state set herein is set on the SCHEDULE screen.
1
Setting the Output Conditions
Taking seam welding in which laser light is continuously output 100 times, as an
example, the output count of "POINT 01" to "POINT 06" and energy are set. The
energy at the beginning/end of laser light output is made weaker by the fade function.
This prevents an overlapped portion at circumferential seam welding against an
excessive burn and makes the welding mark of the final shot inconspicuous.
⇒ The fade function can also be set for other processes than the beginning/end of
welding.
(1) Press the "SEAM" button to display the SEAM screen.
2
Setting the Fade-in/out Function
(1) Press the "SHOT [COUNT]" setting button of "POINT 01."
Enter the laser light output count.
Set 0001 because of the first output count.
⇒ For "SHOT [COUNT]" of "POINT 01", only 0001 can be set.