Amada MF-C300A-SF, Original Instructions Manual, Page: 84 / 199

84
MF-C300A-SF/C500A-SF
4 . Setting the Laser Light Output Schedule
REPEAT Sets the number of laser light outputs per second in the range of 1 to 1000 pps
(pulse per second).
SHOT Sets the number of laser outputs in the range of 1 to 9999.
When the laser output count reaches the set value, the laser output is stopped.
When 1 is set, a single-shot output is performed. When 9999 is set, laser light is
continuously output until a laser stop signal is input.
Fn When this button is pressed, a window to select function is displayed and the fol-
lowing editorial assistant functions can be used.
RESET: Initializes the currently-selected schedule.
COPY: Copies the currently-selected schedule to a temporary memory buffer.
PASTE: Restores data from a temporary memory buffer to the currently-select -
ed schedule.
⇒
For the common items in the upper/lower part of the screen, refer to page 57.
<Notes>
- The laser output value (%) setting range is 0 to 200% . However, the laser output
value cannot be set exceeding the maximum value of "SET POWER" x 100% . If the
laser output value is set to 100%, the value set in "SET POWER" is selected .
- There are limitations of the total time of the laser output time POINT 01 to POINT
20 in combination with values of SET POWER and REPEAT . For details, refer to
"Limitations of Schedule Setting" on page 99 .
SCHEDULE Screen (Flexible Waveform (CW))