Amada MF-C2000A Series, Operation Manual, Page: 45 / 272

1 . Installation Place
45
MF-C2000A Series
Chapter 1 Installation
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
Chapter 1
●
Installation
This chapter explains where to install the laser welder and how to fix it.
⇒ At installation of this laser welder, our engineer will take charge of adjustments.
Accordingly, this Operation Manual does not describe the adjusting method at
a startup. When the laser is transferred to another installation place, it may be
necessary for our engineer to perform inspection and re-adjustments.
1 . Installation Place
The space required for installing the laser welder and the environment suitable
for the installation are explained below .
Install laser welder in a sure place at a level with the ground surface. If the product is
operated in inclined or fallen form, a failure will occur.
⇒ Regarding the requirements of the power supply equipment, refer to the table be-
low.
Input power supply
Current
capacity
Main unit (MF-C2000A Series) 3-phase 200 V/220 V/240 V AC (50/60 Hz) 40 A or more
Chiller (specified one) Single-phase 200 V to 230 V AC (50/60 Hz) 20 A or more
⇒
Perform class D grounding work (Ministry of Economy, Trade and Industry "Tech-
nical Standards for Electric Equipment").
Space Required for Installation
In the installation place of this product, at least 1000 mm of space is required in front,
and at least 500 mm of space is required in back, right, left and upper sides to cool
the internal parts.
Install the product in a place remote from the wall as shown in the figure on the next
page.
Installation and
Preparation Part