Amada MF-C2000A Series, Operation Manual, Page: 41 / 272

3 . Name and Function of Each Section on the Lateral Side and Rear Side
41
MF-C2000A Series
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
Inside of the Connector Panel 2 Section (MF-C2000A-
MC/SC Only)
This section explains each section inside the connector panel 2 .
Function of Each Section inside the Connector Panel 2
(1) EXP1 Connector
Terminal for external network.
Used when the optional EtherNet/IP is used.
(2) EXP2 Connector Terminal for external network.
Used when the optional EtherNet/IP is used.
(3) LAN Connector
Used to connect to the personal computer with the attached LAN cable.
The LAN standard is compatible with 100BASE-TX.
(4) USER I/O Con-
nector
Connector for input and output with the external device (PLC, etc.).
(5) LASER IF (2)
Connector
Short-circuited with the dedicated cable.
When the scanner head unit is not used on MF-C2000A-MC/SC, con-
nect the dedicated short-circuit connector.
(6) LASER IF (1)
Connector
The dedicated cable is connected. Do not remove it.
(7) SCAN POWER
Connector
Power supply connector for the scanner head unit.
(8) SCANNER Con-
nector
For connection to the scanner head unit using the scanner control con-
necting cable. (XY2-100, 16 bits)
(9) TRIGGER Con-
nector
Connects to the optional MM-L300A and outputs the external trigger.
(10) OPT REF Con-
nector
Connector used to output a reflected light.
The output range is 0 to 10 V.
Chapter 2 Name and Functions of Each Section
(3)
(2)
(4)
(1)
(6)
(7)
(8)
(9)
(5)
(10)