Tines stopping during operation
The tines encountered an obstacle, the tool carriers
are blocked:
1.
Raise the implement.
2.
Reduce the PTO shaft speed to approx. 300 rpm.
The cam-type clutch engages audibly.
3.
Re-establish the original PTO shaft speed.
4.
Resume working.
An obstacle is jammed between the tines:
1.
Raise the implement.
2.
Secure the tractor and implement.
3.
Wait until the tool carriers come to a stop.
4.
Remove the obstacle between the tines.
The cam-type clutch is often triggered
Maintenance is required on the cam-type clutch:
1.
If the cam-type clutch is often triggered,
perform maintenance according to the
instructions from the universal joint shaft
manufacturer
or
Contact AMAZONE Customer Service.
2.
Install the universal joint shafts.
Excessive torques on the cam-type clutch:
Universal joint shaft speeds lower than 1000 rpm
cause high torques on the cam-type clutch.
If the cam-type clutch is often triggered,
set the speed of the universal joint shaft to 1000
rpm.
CMS-T-00004519-B.1
CMS-T-00004943-B.1
8 | Eliminating faults
MG7512-EN-GB | C.1 | 29.09.2022 | © AMAZONE
60
