10
(1) Installation Structure: I-Beam (Standard)
Required Components: Mounting Clamp*2, Universal Mount*1, Extension*1, Hex Bolt (M12*60*4 pieces), Hex Bolt
(M12*100*2 pieces), Nylon Hex Lock Nuts, Flat Washers, Spring Washers (Select according to site
specification)
Installing Steps: (1)Attach the Extension to the bottom of the Universal Mount, then pre-tighten the Hex Bolts (M12*100*2
pieces).
(2) After confirm installation position, position the Universal Mount under the I-Beam, assemble one
Mounting Clamp with one side of the I-Beam and then pre-tighten them. The above step will be repeated
on the other side. After finish, apply loctite to all bolts then tighten them all, torque to 60 NM. (overhead
operation).
Attention: Before overhead operation, the safety helmet, safety clothing, safety rope and others should be worn, and
equipment for climbing should be prepared, then all components to be installed need to be put in. When
overhead operating, the safety rope must be confirmed to be fixed.
Breakdown Drawing:
Installation Diagram:
Summary of Contents for AH-5
Page 1: ......