4
be parallel with the ground.) Tighten the knobs just enough to keep the search
coil from rotating or wobbling.
2) Insert the latch on the top of the handle into the assembly hole on the bottom of the
control box. Then slightly push the control box in the direction of IN marked on the
handle to fix the latch in place, secure the control box with fixing screw properly.
3) Unscrew the knob on the search coil and remove the knob connector. Insert the stem
and align the holes on the search coil bracket and the stem. Push the connector through
the holes and tighten the knob.
4) Wind the search coil cable around the stem. Leave enough slack in the cable. Insert
the search coil cable plug into the five-pin jack on the front control box’s housing.
5) Turn the stem’s lock nut clockwise until it loosens. Lengthen or shorten so when you
stand upright with the detector in your hand, the search coil is level with and about ½ to
2 inches above the ground with your arm relaxed at you side. Turn the stem’s lock nut
counter-clockwise to lock it in place.
CAUTION:
•
The search coil’s plug fits into the connector only one way. Do not force the plug
or you could damage it.
•
Do not over tighten the search coil or use tools such as pliers to tighter it.
Installing batteries
1) Turn off the power before installing the batteries.
2) Slide the left and right battery covers off in the direction of the arrow.
3) Place two 9V batteries into the battery compartment matching the polarity symbols (+
and -) marked inside.
Fixing Screw
Latch
Control Box
Assembly Hole
