Always
O
n UPS Systems
M0309_N_Series_ABS_700-3kVA_User_Manual V2.8 2012-06-12
24
11.4.
EPO port (Emergency Power Off)
A customer-supplied switch located remotely can be used to open the EPO
connection and allows UPS output receptacles to be switched off. Since the EPO
shuts down the equipment immediately, orderly shutdown procedures are not
followed by the power management software. The UPS will have to be manually
restarted in order to regain power to the outlets.
11.5.
Network Transient protector (700 - 3000 VA)
The network transient protector, located on the back panel, has both IN and OUT
jacks, and houses a single RJ- 45 (10BaseT) network connector. Connect the input
connector to the jack labeled IN, and the output connector to the jack labeled OUT.
11.6.
Load segments (700 - 3000 VA)
The power management software controls the sets of receptacles known as load
segments, which provides organized shutdown and startup of the equipment. Less
critical equipment can be turned off during power outages saving battery power for
critical loads. The power management software manual has more details regarding
this. The load group status can be viewed from the LCD display and can be changed
if necessary. These load segments are usually handled with the UPS management
software. Refer to chapter 6.5 regarding the two load segments that come with each
model. Necessary information for operation of the unit is covered in this chapter.
Normally the UPS runs automatically, but on those few occasions such as just after
installation, all the starting and shutting down procedures are described herein.
