Alvarion BreezeACCESS Wi2, System Manual

Page: 54 / 252

32 BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Chapter 2 - Hardware Installation
2
Check that the LED on the Wi² is green indicating that the system is working normally.
2.3.9 Configuration and Testing
2.3.9.1 Configuring the SU-ODU
1 Disconnect the cable connecting the WiFi Access Point (AP) from the AP connector on the
Power Supply and Interface module.
2 Connect a PC to the AP connector using the 3 m configuration cable (straight) supplied with the
unit.
3 Verify that the SU-ODU is connected to the SU connector on the Power Supply and Interface
module.
4 Using Telnet, connect to the SU-ODU and configure its parameters. For configuration details
refer to the relevant manual.
5 Verify that the SU-ODU is operating properly and that it connects to the base station. For details
on verifying proper operation and connectivity refer to the relevant manual.
2.3.9.2 Configuring the Wi²
1
Disconnect the configuration cable from the unit and reconnect the cable between the WiFi
Access Point (AP) and the AP connector of the Power Supply and Interface module.
2
Disconnect the cable connected to the SU connector on the Power Supply and Interface module.
3 Connect a PC to the SU connector using the 3 m configuration cable.
4 Using Telnet, log in, and set the country code (available only via CLI) and the AP IP address as
outlined in Chapter 4 - "Getting Started" .
5 Complete the configuration of the AP, using either CLI as outlined in the AP CLI Reference
Guide or the web-based interface as outlined in Chapter 8 .
CAUTION
The Wi² can be connected to either an AC or DC power source, or to both. By default the DC plug is
covered with a waterproof sealing cap which must be removed before connecting to the power
cable. Any socket that is NOT in use must always be protected from moisture and must be covered
with a waterproof sealing cap.
NOTE
Alternatively, instead of disconnecting the SU connector, you can connect a PC to the Console port
of the AP with a console cable (ordered separately) and complete all the configuration using CLI.