Alvarion BreezeACCESS II CX, System Manual

Page: 60 / 78

Chapter 3 - Commissioning
Basic Parameters in 900 MHz Units (SW version 4.5)
NOTE
For compliance with FCC rules, the power input to the 900 X MHz antenna of the C
should not exceed 23dBm. The Transmit Power Control should be set to 1 (delivering
24.5dBm power output) onl
onger RF cable y when using a l with an attenuation of 1.5dB
at least, or when using an external Band-pass filter to comp oss in ensate for the power l
the filter. Such a filter may be required if the equipment is lo ong cated near a very str
transmitter using frequencies that are close to the frequencies used by the
BreezeACCESS equipmen
t.
Table 3-4: Basic Parameters in 900 MHz AUs
Parameter Default Value Comment
IP Address 10.0.0.1
Subnet Mask 255.0.0.0
Default Gateway Address 0.0.0.0
DHCP Options Disable
Access to DHCP From Ethernet Only
ESSID ESSID1
Operator ESSID Option Enable
Operator ESSID ESSID1
HDM Mode Disable
Flexible Hopping Definition 915 MHz According to the spectrum
analy survey. Not applicable
when the Scan Entire Band is
enabled.
sis
Scrambling Mode Enhanced
Manual Sequence Definition lic
Scram ured
to Manual Scrambling.
App able only when
bling Mode is config
Spanning Factor Applicable only for Enhanced
Scram ling with 7 or more
frequencies.
1
b
Cell Extender System Manual
3-10