Alvarion BreezeACCESS II CX, System Manual

Page: 53 / 78

Configuring Basic Parameters
4. Select the required access level, depending on your specific access
rights. A password entry request is displayed.
5. Enter your password and press Enter. The Main Menu is d
Table 3-1: Monitor Port Communication Parameters
isplayed.
Parameter Value
Baud Rate 9600
Data Bits 8
Stop Bits 1
Parity None
Flow Control Xon/Xoff
Connecto Connected COM port r
NOTE
Following three unsuccessful login attempts (using incorrect passwords) from either the
Monitor port or via Telnet, the monitor program is blocked for several minutes. To
enable access to the monitor program during that time, the unit must be reset via SNMP
or by disconnecting/reconnecting power.
1. Connect a PC to the Ethernet port using a crossover cable.
. Run any BreezeCONFIG utility and use the Set IP feature to
configure the IP Addresses of the two units. The MAC addresses are
marked on the Interface Unit. In BreezeACCESS VL units, the MAC
address is also marked on the ODU.
. Configure the PC’s IP parameters to enable connectivity with the
unit.
. Run the Telnet program. The Select Access Level menu is displayed.
. Select the required access level, depending on your specific access
rights. A password entry request is displayed.
Enter your password and press Enter. The Main Menu is displayed.
2
3
4
5
6.
To access the Monitor Program locally using Telnet:
Manual Revision 1.0
3-3