Alvarion BreezeACCESS EZ AU-EZ, System Manual

Page: 47 / 175

Chapter 3 - Commissioning Transmit Power Compliance With Regulations
BreezeACCESS EZ AU-EZ 28 System Manual
3.2 Transmit Power Compliance With
Regulations
NOTE: (FCC 5.3 GHz units)
For full compliance with FCC regulations, if you wish to include one or more of
frequency channels 5270, 5275 and 5330 MHz in the set of frequencies to be
used, then the Transmit Power parameter in the AU should not be set to a value
above "20-Antenna Gain". If there is a need to use a higher value for this
parameter, these frequencies should not be used.
CAUTION
In regions where local radio regulations limit the maximum transmit power of the unit the installer is
responsible to properly set the Antenna Gain parameter (if configurable) according to the actual
antenna being used. This will limit the upper limits of the Tx Power parameter in the AU to the value
of "Permitted EIRP-Antenna Gain".
The Tx Power parameter should not exceed the Permitted EIRP-Antenna Gain, according to the
following table:
Table 3-2: Regulation Maximum EIRP
Country Code Maximum EIRP (dBm)
FCC 5.3 GHz 30 (See NOTE Below)
FCC 5.4 GHz 30
ETSI 5.4 GHz 30
ETSI-F 5.4 GHz 30
Australia 5.4 GHz 30
Universal 5.4 GHz 38
FCC 5.8 GHz 36
UK 5.8 GHz 36
Australia 5.8 GHz 36
India 5.8 GHz 36
Germany 5.8 GHz 36
Universal 5.8 GHz 36