WBSn-2400 and WBSn-2450 System Manual
Chapter 3 - Base Station ManagementSystem
Chapter 3 - Base Station Management
System
51
3.3.5.3
Firmware Banks
In the Firmware Banks section you can switch to the previous firmware version:
Each firmware has its own configuration file. After a firmware upgrade procedure is performed, a new
configuration file is included in the upgrade. This configuration file will adopt the current configuration
settings once the newly upgraded firmware is run. The new configuration file may contain new features
that could modify current configurations. Also, even if no new features are included in the upgrade, but
new configurations were specified by the user, a newer version of the configuration file is created.
If you wish to revert back to the previous firmware and keep using the new configuration file (excluding
parameters that are not supported by the previous firmware), click on the
Switch Bank
button. After
reboot the device will run using the previous firmware and the new configuration file.
If you wish to revert back to the previous firmware and the previous configuration file, you need to
perform a rollback procedure by clicking on the
Rollback
button. After reboot the device will run using
the previous firmware and the previous configuration file.
3.3.6
Reboot Page
To access the Reboot page click on the
System>Reboot
tab in the management function selection
panel.
CAUTION
Check (the default) the
Keep settings
checkbox to save the previous configuration and continue using
it after switching to the new firmware version. If
Keep settings
is unchecked, the new firmware will
start running using the factory default configuration. In this case you may loose the ability to remotely
manage the device.
Figure 3-33: System Backup / Flash Firmware Page, Firmware Banks Section