WBSn-2400 and WBSn-2450 System Manual
Chapter 2 - Base Station InstallationConnecting the Indoor Equipment
Chapter 2 - Base Station Installation
Connecting the Indoor Equipment
18
2.12
Connecting the Indoor Equipment
After mounting the unit with the Ethernet cable connected and verifying proper grounding, proceed to
complete the indoor installation.
1
Insert and crimp a shielded RJ-45 connector to the Ethernet cable. For detailed instructions on how to
prepare the Ethernet cable refer to
“Preparing the Base Station’s Ethernet Cable” on page 116
.
2
Connect the Ethernet cable to the OUT connector of the PoE Injector.
3
Use the power cable to connect the PoE Injector to a mains outlet.
4
Use a standard Gigabit Ethernet cable to connect the IN connector of the PoE Injector to the
networking equipment.
IMPORTANT
NOTE!
The following instructions are for the AC PoE Injector available from Alvarion. For details on
installing the DC PoE Injector available from Alvarion refer to the Quick Installation Guide supplied
with it.
Figure 2-6: AC PoE Injector
To connect the indoor equipment:
