Supervisor 3500 Installation Instructions
Page 32
For assistance: [email protected] +1 (909) 591-8431 PUD3673R1-1
Appendix A - Setting the Home Position
Fig. A2
Fig. A3
Fig. A1
Motor Controller Board
Barrier Wing Home Position
Motor Controller Board
1. Locate the motor controller board in the master or
center cabinet [Figure A1]. The (D2) LED will be
blinking indicating normal operation mode.
2.
Press the 'Test Mode' button for two seconds. The
(D2) LED will be lit solid. You are now in test mode
[Figure A1].
3.
Move the barrier wing a couple of inches in both
directions and then place it in the Home position
[Figure A3].
4. Press the 'Home' button to set.
5.
Press the 'Test Mode' button for two seconds to exit
test mode. The (D2) LED will return to blinking status
indicating normal operation mode.
6. Locate the slave motor controller board in the slave
or center cabinet.
7. Repeat Steps 1 through 5 for the slave barrier wing.
Home
Position
Test
Mode
D1
D2
Activate
