Supervisor 3500 Installation Instructions
Page 16
For assistance: [email protected] +1 (909) 591-8431 PUD3673R1-1
Installation Instructions
Anchoring the Turnstile
1. Place the master cabinet and the slave cabinet in the determined location [see dimensions - Figures 3 -4].
2. Cabinets must be level to each other and square to all neighboring cabinets. This will ensure that all optical sensors are aligned
for optimum performance. Use the following procedure to square each cabinet with respect to the floor and other cabinets:
A. Measure the distance from the inside wall of one
cabinet to the inside wall of the other cabinet, on both the
entry and exit side of the lane for a consistent measurement
[Figure 13A].
B. Measure the diagonal distance from the end of one cabinet
to the end of the opposing cabinet, then measure the
opposing diagonal [Figure 13B]. If these distances are equal,
the cabinets are square.
Fig. 13A
Fig. 13B
NOTE
The lane 1 master cabinet is always the right most cabinet in relation to the unsecured side.
