Page 38 [email protected] +1(909) 591-8431 www.alvaradomfg.com
Installation Instructions
Appendix D - MST47 Installation
1.
Determine where the turnstile will be installed.
Consider the overall footprint size of the unit when
determining the installation location (Figure D1). The
slab requirement to install the MST47 is
10' x 8.5' x 4". Once the installation location has
been determined, use a chalk line to mark the
centerline of the turnstile.
NOTE
The overall height of the MST47 is 94". However, an
additional 3" of clearance must be added for service
and maintenance.
2. Reconfirm the centerline location for the Yoke
(Figure D2).
3. Continue installation as shown in the "Yoke
Installation" section.
Default entry rotation is counterclockwise. Confirm correct
entry direction prior to installation.
These instructions are for installing the Yoke section of the MST47. When complete, please refer back to the "OV
Installation" section.
Fig. D1
Fig. D2
MST47 Illustrated Parts List
Entry Side
(Unsecured)
Exit Side
(Secured)
105.50"
(2680mm)
52.75"
(1340mm)
52.75"
(1340mm)
CL
51.88"
(1318mm)
Bottom Bearing
Plate Center
CL
Yoke
(Qty 1)
Roto
(Qty 1)
OV
(Qty 1)
MST47 Installation Instructions
51.25"
(1302mm)
51.88"
(1318mm)
