Alutech CU-TR230, Installation And Operation Manual

Page: 112 / 138

CONTROL UNITS СU-TR230 / СU-TR400
110 110
SETTINGS
6.4 RESET TO FACTORY SETTINGS
Y
Reset to the factory settings will restore the setting values that are set by default when the con-
trol unit has been delivered ( Table 13).
Y
ATTENTION!
Door position settings will not be saved. To set the door position, follow the steps
in section ‘6.1. Setting the end position of doors’.
The previously recorded radio remote controls and cycle counter data ( Table 16) will be saved.
Table 1 5
1
Press and hold for ~5 s, until entering the setting menu
5 s
2
After the inscription P1 appears, press
3
After the inscription P0 appears, press
4
After the inscription F0 appears, press
5
After the inscription ‘ – – ’ appears, press and hold it for ~5 s
until a dot appears on the display, which will mean resetting all settings
5 s
6
After the inscription F0 appears, press twice to exit the setting
menu
×2