Altusen KN2132, User Manual

Page: 190 / 310

KVM Over the NET™ User Manual
174
Mode
An explanation of the Mode items is given in the table, below:
Item Explanation
Enable ICMP
If ICMP is enabled , the KVM Over the NET™ switch can be
pinged. If it is not enabled, the device cannot be pinged. The
default is Enabled.
Enable Multiuser
Operation Enabling Multiuser operation permits up to 32 users to log in at the
same time to share the remote bus. If not enabled, only one user
can log in at a time. The default is Enabled.
Enable Virtual
Media Write
Operation Enabling Virtual Media Write Operation allows redirected virtual
media devices on a user’s system to send data to a remote server,
as well as being able to have data from the remote server written to
them.
Enable Local
Virtual Media Enabling Local Virtual Media allows USB storage peripherals (CD/
DVD, HD, flash drives, etc.) connected to the KVM Over the NET™
switch to appear and act as if it were installed on a remote system.
Browser Service Enabling Browser Service allows the administrator to restrict
browser access to the KVM Over the NET™ switch. After checking
Browser Service , drop down the listbox to select the degree of
restriction:
Disable Browser: means no browser access is permitted.
Disable HTTP: means browser access is permitted, but users
must access the switch with an HTTPS URL.
Disable HTTPS: means browser access is permitted, but users
must access the switch with an HTTP URL.
Disable
Authentication If Disable Authentication is checked, no authentication procedures
are used to check users attempting to log in. Users gain
Administrator access to the KVM Over the NET™ switch simply by
entering combination of username and password.
Note: Enabling this setting creates an extremely dangerous result
as far as security goes, and should only be used under very special
circumstances.