Altuscn KN2116a, User Manual, Page: 32 / 306

KVM Over the NET™ User Manual
16
Stacking and Rack Mounting
The KVM Over the NET™ switch can be stacked on the desktop or rack
mounted in a variety of ways. The following sections take you through the
procedures for each method.
Stacking
The KVM Over the NET™ switch can be placed on any appropriate level
surface that can safely support its weight plus the weight of its attached cables.
To place the switch, or to stack units if you are daisy-chaining them, remove
the backing material from the bottom of the rubber feet that came with your
package, and stick them onto the switch’s bottom panel at the corners, as
shown in the diagram, below:
Note: To ensure adequate ventilation, allow at least 5.1 cm on each side, and
12.7 cm behind the unit for power cord and cable clearance.